There seem to be some minor differences between the original A4RA transmission and newer B4RA replacement. My coupling was pushing the Torque Converter too far forward, causing it to jam against the transmission bell housing. After removing and reinstalling the motor 6 times, I think I finally figured it out. I spent a good 45 minutes analyzing all my photos I took, then I went out to my coupling and did more measurements. The A4RA transmission allowed the TC to be pressed more into the transmission without much complaining, where the B4RA just doesn't budge without anything but perfection. The motor is now back together and bolted into the EV. I checked it with a 12 volt spin up and it seems fine, with a little coupling bolts needing tightening which I did.
Tomorrow I am going to reinstall the control tray and see what happens. Hopefully it will be driving again, a few times around the block will tell me.
Then I will get to my Zilla! I really haven't looked at it yet, mainly cause I don't want to get distracted from actually fixing the current problems. I am hoping to do some test runs before we leave for Thanksgiving dinner, then I can drag along my Zilla manual and figure out how I am going to install it.
No comments:
Post a Comment