Tuesday, June 2, 2009

Adapter Plates, 2.0

It turns out that the machine shop just doesn't have the time to work on my plates. So today I went down and picked up my FB1-4001A, sacrificial transmission and the new plate stock. I then went off to Home Depot and picked up a new 15" Drill Press, new bits and new DeWalt batteries then spent the day setting up the equipment.





The drill press seemed more complicated than the EV! After setting up, I went straight to work. It goes so much faster now that I have the old plates to use for patterns, and all the right equipment does wonders. I only spent about 30 minutes actually making the plates today, but I will be working on them for the next few nights with the *hope* that I can install it this Saturday. I am also taking my time and making these new plates as professional looking as possible, vs my other "hacked up" plates, which did look pretty bad up close, although they worked perfectly.

No comments:

Post a Comment

Total Pageviews